FUGA FLEX

FUGA FLEX

Cement Based, Flexible Joint Mortar (1-12 mm)

Advantages

  • Durable and long lasting.
  • Perfect adhesion in the applications at the width of 1-12 mm.
  • Easy to prepare and apply.
  • Resistant to water, frost and moisture.
  • Resistant to intense pedestrian traffic.
  • Fireproof.
  • 22 different colour options.
Product Features Surface Preparation Application Documents

Description

  • Cement based and decorative joint mortar in Class CG2 WA reinforced with chemical additives, polymers and mineral fillers and allowing 1-12 mm application width for tiles, ceramics, marbles, granites, natural stones etc.


Usage

  • Indoors and outdoors,
  • Walls and floors,
  • Floors with intense pedestrian and cargo traffic,
  • Areas with sudden temperature changes such as façade and floor heating system,
  • Joint applications on tiles, ceramics, granites, marbles and natural stones

Technical Information
  • Colour: White and Coloured 
  • Corrosion resistance (EN 12808-2): ≥ 2000 mm3
  • Bending strength (EN 12808-2): ≥ 2,5 N/mm2
  • Bending strength after freeze-thaw cycles (EN 12808-2): ≥ 2,5 N/mm2
  • Pressure resistance (EN 12808-2): ≥ 15 N/mm2 
  • Pressure resistance after freeze-thaw cycles (EN 12808-2): ≥ 15 N/mm2
  • Contraction (EN 12808-4): ≥ 3 mm/m 
  • Water adsorption for 30 minutes (EN 12808-5): ≤ 2 g
  • Water adsorption for 30 minutes (EN 12808-5): ≤ 5 g
  • Depends on + 23 ± 2°C temperature and 50 ± 5% relative humidity conditions.

Surface Preparation

  • Adhesive must be cured prior to the joint application.
  • The application surface must be cleared of dust, dirt, detergent etc. which may prevent adhesion.
  • Joint gaps must be cleared of adhesive residuals and adhesive residuals which fill joint gaps must be mechanically removed.
  • Absorbance must be minimized by way of dampening joint gaps with clean water.

Mixing

  • Pour sufficient amount of clean water in a clean mixing container. Slowly add Fuga .flex to the water and mix it with the help of a mixer with 400-500 cycle/minute until you obtain a smooth mixture (for 3-5 minutes).
  • Mature the mixture for 3 minutes and mix it for further 1-2 minutes.
  • The mixed mortar is available for use.

Application

  • The prepared mortar is spread on the surface and joint gaps are filled with cross movements with the help of a rubber spud.
  • Excess mortar must be removed from the surface by means of stripping.
  • The first wiping process must be performed with circular movements after 15-30 minutes depending on ambient temperature with the help of a damp sponge.
  • The sponge must be cleaned frequently during the wiping process and wiping with an excessively damp sponge must be avoided.
  • Primary wiping process must be performed through a dry cloth after making sure that the applied joint sealant will not overflow.
  • Do not apply the product under direct sunlight or when the surface and air temperature is less than (+5°C) or higher than (+35°C) or in case of strong wind.
FUGA FLEX
Teknik Bilgi Föyü
0,13 MB